Built in 2011 · 330 hp on 91 octane

2000cc 2-stroke triple

Robert Cote, the CEO of The Mod Shop, wanted to build an unspoken and unheard of engine for his dragster back in 2011. Some points that had to be achieved with a project like this: it had to be lightweight, compact, and make lots of horsepower. Going with a 2-stroke engine was a great way to make power while staying compact and light — fewer parts to make and fewer parts needed inside the engine. For the size of engine he wanted, everyone told him he couldn’t build one and would not be able to get a crank to make it happen. When you tell Robert that something can’t be done, he will go and prove you wrong.

He planned out what size and how many cylinders he wanted, what type of fuel system he was going to use, whether it was carbureted or fuel injected, what kind of ignition system, and so on. He then custom machined a crank for the engine and pressed all the pieces together. Once the crank was built we teamed up with Ralph at Split Second Performance, who machined the crank cases and head out of a block of aluminium on their CNC mill. We went with blank cast cylinders since it was cheaper and the work for the bore size and Nikasil plating was already done. When the cylinders arrived we ported them to the specs we wanted. We found Wiseco pistons already made to the bore size needed, so no custom pistons were required. The heads were machined out of another block of aluminium to the compression ratio and squish clearance we wanted.

For the correct centre spacing of each cylinder, the Arctic Cat 900 carbs worked perfectly and also let us keep it de-tuned. The carbs were gone through and the jets changed for an approximate starting point. The flywheel housing was machined to use the 800 Ski-Doo Mach Z ignition system, since it was made for a triple cylinder 2-stroke and included electronic reverse. We also worked with Jaws Performance to design one-of-a-kind custom pipes for the engine.

Once assembled it went on The Mod Shop dyno and was properly tuned. With everything working properly it put out 330 hp and 222 ft-lb of torque on 91 octane gas. There is a lot of performance left in the engine, but we kept it de-tuned so we could get everything figured out with the car and the clutching. The primary clutch was used on a land speed record snowmobile — no other clutch out there could hold up to the abuse big horsepower engines put out. We have since added a 100 hp shot of nitrous on each cylinder when burning av-gas, once the clutching was close.

In progress

Turbo Renegade 1000

We are building a custom turbo Renegade for our good customer Bill Ford. This project is using the factory Maverick turbo engine with the factory turbo at the moment, with a possible turbo and cam upgrade in the future once it is all running. At the moment we have the turbo mounted and the exhaust system built, and we are working on the intake system.

Product development

Polaris 850 Sportsman

We are working on some new products for the Polaris 850 ATVs. We have the Powerhouse full exhaust and the slip-on made, and both gave great results. We’re working on another 10+ hp with a bolt-on part. Stay tuned.

Customer project · dyno & tuning

1300cc 2-stroke twin

We helped out with a 1300cc twin project that Craig Sparks was working on. He bought a blown up Polaris 800 Pro chassis, removed the engine and stuffed this 1300cc twin inside. He had a fun time stuffing the massive twin pipes underneath the hood, but he got it done. We helped out with the project by dynoing the engine to get it tuned, and with some pointers along the way when he had questions.