Clutch Machining

Clutch Machining

We offer Yamaha, Kawasaki, Suzuki and Can-Am primary clutch machining. The machining improves bottom end power without losing any top end speed — some models even gain top end speed. Improved belt life on Kawasaki and Can-Am, and it allows for a better shift rate.

$200 – $300 CAD, depending on the model

Yamaha 700 Water Pump Machining

Yamaha 700 Water Pump Machining

Is your Yamaha 700 ATV or UTV running hot? We machine the Yamaha 700 water pump covers to prevent cavitation. The factory water pumps have too much clearance from the impeller to the cover, which causes cavitation and stops the coolant circulating properly. Machining the cover brings the clearances tighter so it pumps the coolant properly and gets cooled by the radiator.

$75 CAD

Dyno Services

Dyno Services

We can dyno your ATV, snowmobile or dirt bike and do fuel and ignition tuning — or simply see what horsepower your engine has. When fuel tuning we can hold throttle position while fluctuating rpm, or vice versa, to properly tune every section of the map. This service also tells you what rpm your engine is making peak power at, so you can adjust clutching to the proper rpm.

$150 / hr CAD

Flow Bench Testing

Flow Bench Testing

We can flow bench test your heads and intake to see the gains after head porting. When we port and polish heads or intakes we run them on the flow bench to ensure each cylinder will flow the same. We can also flow test exhaust pipes to check whether they are too restrictive for the engine.

Contact for pricing

Piston Machining

Piston Machining

We can machine pistons for compression ratio, deeper valve pockets and valve pocket angle — cut to the spec your build actually needs.

$60 CAD each piston

Cylinder Boring & Resleeving

Cylinder Boring & Resleeving

We can bore cylinders to the next size over, or, if it has been bored all the way out already, we can resleeve it back to standard bore.

Boring $150 CAD · Resleeve $250 CAD each cylinder

Crank Rebuilding

Crank Rebuilding

Since 2001 we have offered a crank rebuilding service that we do in house — pressed, trued and checked here rather than sent away.

Contact for pricing

Head & Cylinder Porting

Head & Cylinder Porting

Over the years we have learned what works for head porting, whether it’s for a 4-stroke or a 2-stroke engine. Everything we port goes across the flow bench before it goes back in the crate.

Call for pricing

Throttle Body Boring

Throttle Body Boring

We can bore the throttle body on your Can-Am. We can bore the 46mm out to 51mm, and the 54mm out to 59mm. Shipping of the customer’s throttle body is required.

$250 CAD

Engine Building

Engine Building

If you’re not comfortable rebuilding your engine, no worries — we can do it for you. We have the expertise in rebuilding and modifying engines. Anywhere from stock to full out mod, the engine is in good hands with us.

$150 / hr CAD

Custom Builds

Custom Builds

We can do custom builds. Contact us with your idea, your goals and your budget, and we will tell you honestly what it takes to get there.

$150 / hr CAD